I picked up the Leclerc warping mill I ordered a few weeks ago, I got the tabletop model. After a disastrous experience with a paddle and the warping board I determined it was time to have a warping mill again. I sold my old one with the loom before I came to San Francisco.

Previously I had the substantially similar Harrisville model, which is kinda nice as it has an integral brake to hold it in place while chaining off. I actually liked that quite a lot. But the Leclerc was about $50 less and comes already finished. The price was the smaller issue, more is that I just don’t have time to deal with the requisite sandpaper and can of oil. I can live without the brake, there are other options that can be temporarily installed as needed.

But now I get to assemble the thing. One difference is once this gets together, it’s not coming apart. The Harrisville was easier to put together (after finishing) because everything is held with wing nuts. That means it also came completely apart. That is a small advantage in storage as you can break it down to basically a pile of rods and the base.

The Leclerc has screws to hold the frame together. There are pilot holes but it is still difficult, I don’t have the strength to do it without assistance as it takes two hands to turn the screwdriver. I’ve got it partly assembled, and next time DH has a few minutes I’ll get the rest. And given that the screws go into end grain wood, it’s a one-way trip. The cross bars with the pegs do come off and the two pieces and the central rod come off the base, but that’s the extent of disassembly.

I haven’t decided if I want to sell the warping board, it does break down and there is something nice about having it to cart to demos or lend to students. This is what the storage unit is for.

Leave a Reply

Creative Commons License

© 2004-2007 Andrea Longo
spinnyspinny at feorlen dot org