SpinnySpinny

With the sample spinning finished I went looking for some more fiber in the closet to work on. I pulled out something that has been sitting around a while to try to at least get all the fiber spun. I originally bought two packages of the Ashland Bay multicolor merino with the intent to make a scarf, woven of singles. I spun the first about three years ago and then it got put aside.

I kept the little reference sample I was using, but in getting back to it I had a hard time keeping the same size. So the new skein turned out a little finer. This isn’t a disaster, I can measure the two ends together so they are mixed in the warp and evenly distributed. But still not exactly what I was after. I’ve had other yarns where one skein ended up very different from the others and sometimes there just isn’t much you can do about it but decide you were going to make a different project. My usual practice of spinning way too much yarn generally saves me but isn’t exactly the most efficient. Better is to work more on matching the existing yarn, or just finish all the spinning at once in the first place.

With that dubious success over with, I picked up another long-abandoned project and started spinning more of the merino from the county fair yarn. I have one full bobbin, two partial and tons of fiber. I figure I can at least get through the stuff already combed that has been sitting in a box for over a year. I’m doing better on matching the existing yarn, as I still can compare how it looks on the bobbin along with my reference sample. Plus this was intended to be a 3-ply, which hides a multitude of sins.

I’ve got both yarns skeined, blocked and measured. The second S yarn came out slightly finer but not enough that it’s a problem. I still have fiber left so I can always spin more. It came out a bit hairy, what I would expect for a coarse fiber, so I’ll need to thread it on more shafts than you might think for simple plain weave. In this case, I think 4 should be fine.

Z 643m, 145g
S 707m, 142g

The hard part is going to be keeping them straight. I already had to check my numbers several times to make sure I got the right measurement with the right yarn. I hope to have this warped and well underway while The Boyfriend is out of town else I’ll never get enough quiet time to get it done right.

The Z bobbin of romney is done and I’m well along on the second S one. There are some pictures I haven’t gotten off the camera yet, but I can tell you exactly what it looks like: a skein of 400-ish meters of off-white singles. Rather a lot like this, actually, although a bit finer and nowhere near as even. I’d guess it’s around 25 wraps per inch, for those who pay attention to such things (I usually don’t.)

I left it on the skein winder and sprayed it with water rather than wash, I don’t want it to fluff up at all and drying under tension would be a good thing. The skein winder is wood, but I long ago finished the pegs in clear nail polish so it could handle a little water. It’s still not a proper yarn blocker, but it will do for now. I started to count the finished skein to get an accurate length measurement, but I tried it the day I was home sick and managed to lose track before I could write it down.